Tools

Custom 7/8 & 7/16"wrench for the nuts on the Locks

From Jason Czito

Custom tools: The lock wrench you have on your website should be mandatory for any casino. VSR came out to do our locks and they had another that we use too: a 7/16" nut driver with the forward edge ground to a sharp edge.

This lets you put the driver on the nut without having to pry back the
washer fingers - the edge should be sharp enough to fit between the closed
fingers and the nut. Saves a lot of time.

From Jason Czito

Jumper cables for the optic switch on IGT games. This helps immensely when
troubleshooting faulty door optics or open door tilts. Some of their
machines have so many switches in line for the main door signal that
troubleshooting them can be a pain. This also allows you to work on an S2000
with the door open. Note that the cable cannot simply jump the pins of
either optic: you have to actually fix two cables with optics on the end
facing each other. Heat shrink tubing works for ours.

	After turning on the Soldering station is ready to use in less then 15 Sec The Desoldering station is ready in less then 46 sec
This Surface mount unit pays for itself and is a lot better then trying remove or solder Surface mount Devices with a soldering Iron and solder wick

Put a unit like this on wheels - Graveyard shift could clean the monitors on the casino floor Dirty Monitors run hotter, dry out caps & cause other components damage This would help to keep them Clean	The Guys at the TI built this (Think it was Brian). Grate Ideal - A box for the Monitors, Vacuum on top, vacuum up the dirt and dust. a compressor to blow off the dirt and dust from the monitor. A Door to keep the Dirt & Dust inside

Now if there was a fix for Monitors Fills

it's called

TITO