
|
NOTE: |
|
When power is turned on, The self-test
sequence begins. |
|
a) The display will
illuminate: KOBETRON |
|
b) approximately 30 seconds the version number (1.2) will appear on
the Display |
|
c) After another 20 seconds the display will read: UNIT-OK |
|
Begin by checking for Electronic ID |
|
PRESS |
DISPLAY |
EXPLANATION |
|
Device Type |
|
|
|
Execute |
27c256 (example) |
Shows the EPROM ID size |
|
|
NO ID |
Use Manual ID Method |
|
PRESS |
DISPLAY |
EXPLANATION |
|
Device Type |
|
EPROM Manufacture |
|
Device Type |
32 KBTE (example) |
Memory size of EPROM |
|
PRESS |
DISPLAY |
EXPLANATION |
|
Verify |
|
|
|
Execute |
CALCULAT then |
Prefix SIG |
|
|
CHIP BAD |
EPROM IS BAD |
|
PRESS |
DISPLAY |
EXPLANATION |
|
Verify |
|
|
|
Verify |
|
|
|
Execute |
CALCULATEX then |
S indicates an Extended signature |
|
PRESS |
DISPLAY |
EXPLANATION |
|
Menu |
ELECTRON ID |
|
|
Down Arrow |
MANYAL ID |
|
|
Select |
EPROM |
If you would like to test page or Flash Devices, press
up/down arrows until desired device type |
|
Select |
|
The prefix |
|
Note: Some EPROMS may need to have a different Manual ID
selected then what is on the EPROM label. See the GUIDE FOR MANUAL ID
(Instruction Manual) that is with the KOBETRON MT-2000 MEMORY TESTER |
|
PRESS |
DISPLAY |
EXPLANATION |
|
Select |
Selected |
|
|
PRESS |
DISPLAY |
EXPLANATION |
|
Verify |
|
|
|
Execute |
CALCULAT then |
Prefix SIG |
|
|
CHIP BAD |
EPROM IS BAD |
|
PRESS |
DISPLAY |
EXPLANATION |
|
Verify |
|
|
|
Verify |
|
|
|
Execute |
CALCULATEX then |
S indicates an Extended signature |