GEN 2 Printers

Did you know – if you had a Gen 2 Netplex but needed an RS232 or Vise versa?

It’s easy to make the change.

1)

Remove the 4 screws – life the plastic cover (Caution – watch out for the ribbon cable)

Both boards are the same – if you look at the 2 jumpers (J19 – J20) on the bottom right – of this picture.

This one is set for NETPLEX

For an RS232 – Just move the Jumpers – to the right (Like the photo below)

Insure you have the correct firmware

Thank you - Mike & Richard from the Tropicana

for this information