Bent Screwdriver
The #1 E-Prom Removal Tool
Click Link Below
Some may say the Tool of a Journeyman would be the bent
screwdriver
and the Apprentice would use the staple Puller. Help Limit the
damage that can be done.
The Staple puller is even sold by AG&E & Happ
Controls as an E-prom removal tool.
I would say the Staple Puller is a grate tool for removing
E-proms. I personally do not use it - I have one in my locker, as a back up
tool.
The Bent Screwdriver is the tool I use, as it does have a wider
range of use.
Just few examples -
I use the bent Screwdriver daily.
|
|
Removing a PCB from a standoff the staple Puller may also do the job. |
|
When you need just a little
more leverage on the dividers, the staple Puller may also do the job. |
|
|
|
Removing small IC's after they
have been unsoldered, the staple Puller is too big for this job. |
|
Removing small surface |
|
|
|
When you need just a little
more leverage on Coin Mech glued together with a drink, the staple
Puller may also do the job but it may be too big. |
|
When you need to get around
tight corners and hold the heat Sink, to line up holes for screws.the staple
Puller is too big for this job |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
